Removal and installation of the working cylinder

Removal and installation of the working cylinder of the clutch should be carried out as follows:

- Spanner unscrew the hose from the hydraulic drive of the working cylinder. The end of the hose to plug stopper, preventing the fluid drain;

- Unscrew the two screws on the clutch housing of the cylinder and remove the cylinder. Do not lose the puck;

- When installing shims installed notches to the clutch housing;

- Establish a master cylinder so that its rod entered the circular recess clutch fork and then bolted;

- Connect the hose to the cylinder and pump clutch (see. Sect. 6.8).