add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz Sprinter (from 1995 to 2000, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz Sprinter
Home
 
Mercedes-Benz
Sprinter
General Information
Engine
Greasing system
Cooling
injection systems and exhaust
Coupling
Manual transmission
Front Axle
Rear axle and driveshaft
Front and rear suspension
Steering
Brakes
Electrical system
Description of instruments for measuring voltage, current and resistance
Accumulator battery
Alternator
Starter
Checking starter
Removing and installing starter
Repair of starter
Possible malfunctions of a starter
Lighting
Rear lights
The turn signal and alarm
License plate light
Wipers
Indicators and tools
Windscreen
Circuit breakers
Reading wiring diagrams
Tires and wheels
Automatic Transmission
Map service
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Possible malfunctions of a starter



Solve the problem of on-site troubleshooting recommendations presented here will help.
When you turn the key in the ignition starter turns slowly, does not start or it is turned slightly and stops. If the warning lights are lit or poorly extinguished, first check the battery charge. Unplug the power cord, or oxides of the starter or the starter circuit on "weight" may be due to the following reasons. If you disconnect the battery before this, perhaps its terminals are not well connected. Otherwise, start the engine should use the "Booster" or towing.
If the warning light stays on and the engine compartment audible clicks may hang rod magnetic switch. You can try to knock the metal object on the traction relay - usually the stock is released. If this is not successful, it can be assumed that the brushes are worn or contaminated contact traction relay. In this case, remove the starter and replace the traction relay and / or a brush. If the warning light turns on but the starter does not produce any sound at all, check the connection between the battery and the starter.
If audibly that the starter turns, but the crankshaft of the engine is not turned, it can be assumed fault relay traction drive mechanism or damage to the teeth of the flywheel and the drive gear, thereby engaging them occurs. In this case, engage first gear, slightly propel the car forward again to put a starter. If the attempt fails, replace the starter.
If the starter after the engine continues to rotate, while the ignition key is released, it is possible, "freezes" the traction relay, ie contact does not open (may be defective and the ignition). If this occurs, you must immediately stop the engine.
If after starting the engine continues to rotate the driving gear (determined by the howling sound) may not be returned to its original position lever or gear itself hangs in the gears. In this case, apparently, you need to install the new starter and / or flywheel. In any case it is necessary to dismantle and to check the starter.




« previos page
Repair of starter
next page »
Lighting

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.