REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz M-Class (W163, 1997 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W163
		Introduction
		Controls and receptions of safe operation
		Current care and maintenance
		Engine
		System of cooling, heating and air conditioner
		The power supply system and exhaust
		Systems of an electric motor
			Ignition and engine control
				The basic data and security measures
				Checks control ignition and injection
				Troubleshooting - general information and preliminary checks
				Check and adjust the ignition timing
				Spark plug
				Removing and installing ignition coils, - petrol models
				Removal and installation of the crankshaft position sensor (CKP)
				Removal and installation of the camshaft position sensor (CMP), - the engine 111 series
				Removing and installing the camshaft Hall sensor - petrol engines series 112, 113 and 612 series diesel engines
				Removing and installing knock sensors (KS), - Petrol Engines
			System of preheat of the diesel engine
			Diagnostics of systems of electronic control and diagnostic equipment
			Charge and start systems
		Manual box of a gear change
		The transmission automatically processed
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric

printable version

Removal and installation of the crankshaft position sensor (CKP)

Details of the sensor CKP (L5) of the engine 111 series

Details of the sensor CKP (L5) engine series 112 and 113

PERFORMANCE ORDER

Details of installation of the CKP sensor petrol engines are shown in the illustrations, if necessary, remove the air cleaner.
After replacing the CKP sensor is necessary to make reinitialization control module using a special diagnostic equipment - wise to entrust the implementation of this procedure service specialist.

Diesel models

Details of installation of the CKP sensor Engine Series 612

1 - Pin
2 - Bolt
L5 - CKP sensor

PERFORMANCE ORDER
Details of installation of the CKP sensor diesel engine series 612 shown in the illustration, which includes all the links in the text
Poddomkratte car and establish it on props.
Remove the lower section of the soundproofing.
Disconnect the connector (1).
Remove the retaining bolt (2) and remove the gauge CKP (L5).
Installation is in the reverse order.

« previos page
Removing and installing ignition coils, - petrol models

next page »
Removal and installation of the camshaft position sensor (CMP), - the engine 111 series