printable version

Removal and installation of antenna sites

Installed on the roof antenna cell phone (code complete EV5)

Details of the installation of the stationary antenna cell phone (code complete EV5)

1 - Connector 2 - Lock 3 - Protective Cover	A2 / 22 - Antenna N70 - panel overhead console

PERFORMANCE ORDER

Turn on the auxiliary battery and connect it to a standard battery, then disconnect the negative cable last. 7 - Auxiliary battery 8 - terminal positive wire module 9 - negative terminal wire module W10 - Ground Battery Remove the roof console (N70) (see. Section Removal and installation of the roof console panel). Disconnect the connector (1) the upper wiring telephone antenna (A2 / 22). Remove the clip (2). Remove the protective cover (3), and then using a special stripper (210 589 04 33 00), release and remove the antenna assembly (A2 / 22). Installation is in the reverse order - to fit the protective cover (3) uses a special mandrel (210 589 05 33 00). Finally, make the DTC reading and clearing of system memory on-board self-diagnostic scanner using STAR DIAGNOSIS (6511 1801 00) (see chap. Systems of an electric motor).

Outdoor Antenna radio / cell phone (model Cabriolet)

Details of installation of outdoor antenna assembly models Convertible corresponding complete set (codes EF1 ÷ EF4 and EF7)

1 - Aerial cable 2 - Screw 3 - Nut	4 - Holder A28 - The antenna assembly

Viewed here antenna assembly used on models Convertible equipped with audio systems such as Audio 10/30 RDS system and Handsfree For portable phones Nokia 6210 (complete codes EF1 ÷ EF4 and EF7).

PERFORMANCE ORDER

Remove the antenna assembly (A28). Remove the locker arch protection of the right front wheel. Turn the steering wheel all the way to the right. Using a wrench through the wheelhouse, disconnect the antenna cable (1) from the screw (2). Tighten the bottom nut (3), remove the screw (2). Remove the holder (4) and nut (3). Installation is in the reverse order.

Front aerial Global Positioning System (GPS)

Details of the antenna GPS navigation system

1 - Front grille 2 - Cover the headlight 3 - Fixing nut	A2 / 23x1 - Built-in GPS A2 / 23 - GPS antenna

PERFORMANCE ORDER

Remove the front grille (1) and facing the cover (2) of the left headlight unit (see chap. Body). Disconnect the connector (A2 / 23x1). Release the fixing nut (3) and remove the antenna assembly (A2 / 23). Installation is in the reverse order.