printable version

Removing and installing CD-changer / TV-tuner

CD-changer (code complete ER5)

Details of the installation CD-changer for example Touring models (1 of 2)

2 - Nuts A2 / 6 - CD-changer	A2 / 42 - TV-tuner

Details of the installation CD-changer for example Touring models (2 of 2)

4 - Connector harness the power supply to the CD-changer	5 - Connector fiber optic cable

PERFORMANCE ORDER

Remove the CD-changer round magazine. Turn on the auxiliary battery and connect it to a standard battery, then disconnect the negative cable last. 7 - Auxiliary battery 8 - terminal positive wire module 9 - negative terminal wire module W10 - Ground Battery On models corresponding complete set (code EM9) Remove TV-tuner (A2 / 42) (See below.). Loosen the four nuts (2) Disconnect the connectors (4 and 5) on the rear side of the assembly CD-changer (A2 / 6) and remove the latter. Immediately plug the connector waveguides connect the fiber optic cable (5) with special light-proof caps. Installation is in the reverse order. Finally, make the DTC reading and clearing of system memory on-board self-diagnostic scanner using STAR DIAGNOSIS (6511 1801 00) (see chap. Systems of an electric motor) and perform basic programming.

TV-tuner (code complete EM9)

Details of installation of a TV-tuner (1 of 2)

A - Equipped vetrootboynikom cover	B - Support vetrootboynika

Details of installation of a TV-tuner (2 of 2)

1 - Plastic frame for the installation CD-changer 2 - Carpet panel 3 - Loosen the screws	A2 / 42 - TV-tuner X1 / 27 - Antenna Connector X1 / 28 - Connector wiring

PERFORMANCE ORDER

On models corresponding complete set (code ET2) activate the service mode of the emergency call TELE AID (see. Section Activate / deactivate the service mode of the emergency call AID TELE). Turn on the auxiliary battery and connect it to a standard battery, then disconnect the negative cable last. 7 - Auxiliary battery 8 - terminal positive wire module 9 - negative terminal wire module W10 - Ground Battery On models corresponding complete set (code V57) Remove the luggage compartment lid. Remove equipped vetrootboynikom cover (A), - three push-button latch on each side. Remove the left support bracket (B) vetrootboynika. On models corresponding complete set (code V53) Remove the left storage compartment. On models corresponding complete set (code ER5) remove the plastic frame (1) for the installation CD-changer (See above.). Slightly lifting the side panel trim, carpet, remove cover (2) of the left wheel arch. Remove the two screws and remove the carpet trim panel surrounding the floor. Disconnect the antenna cable connectors (X1 / 27) and wiring (X1 / 28). Remove the four screws (3) and remove the TV-tuner (A2 / 42). Installation is in the reverse order - on the model of the corresponding configuration (code ET2) deactivate service mode of TELE AID (see. Section Activate / deactivate the service mode of the emergency call AID TELE). Finally, make the DTC reading and clearing of system memory on-board self-diagnostic scanner using STAR DIAGNOSIS (6511 1801 00) (see chap. Systems of an electric motor).