 printable version
Removal and installation of the rotor wheel ABS sensors
The front sensors Details of the installation of the rotor of the front wheel ABS sensor
| - Disassemble the drive shaft (2) (see chap. The transmission line).
- Clamp the shaft (2) in a vise.
- Inst 2 mm and broke it with a chisel, remove the rotor, - try not to damage the shaft.
- Before landing on the shaft, heat the replacement rotor to a temperature of about 80 ?� C, and then use a suitable mandrel.
|
|
Rear sensors  | Installation Details ABS outer rotor landing on models with drum brakes rear wheels |
 | Installation Details ABS inner rotor landing on models with drum brakes rear wheels |
 | Details rotor installation of ABS on models with disc brakes rear wheels |
| - Remove the axle shaft (2) and disassemble it (see chap. Transmission Line) and clamp in a vice.
- Using a suitable tool, remove the rotor (1) from the axle shaft.
- Installation is in the reverse order.
|
|
|
