add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz G-class
Home
 
Mercedes-Benz
G-class
Introduction
Controls and operation receptions
Current care and maintenance
Engine
System of cooling, heating, ventilation and air conditioning
The power supply system and exhaust
Systems of an electric motor
Automatic Transmission
Specifications
Troubleshooting - General Information
The general principles of operation of the transmission control system, the control signals
Adjustment of a drive switching AT
Removal and installation of electro-hydraulic control unit switching
Removing and installing AT torque converter
Removing and installing selector module (ESM)
Removal and installation of the sensor output speed AT
Removal and installation of cooler ATF
Flushing cooler ATF and oil lines
Removal and installation of the electronic transmission control module (TCM / ETC)
Transmission Line
Brakes and auxiliary systems
Suspension and steering
Body
Onboard electric
Wiring
 


Hit Counter by Digits


print page printable version

Removal and installation of the sensor output speed AT



Details of the sensor output speed AT (1 of 2)

1 - lever release latch bonnet
2 - Cover
3 - Connector

4 - sensor output speed AT (B49)
5 - Bolt
6 - grommet cable

Details of the sensor output speed AT (2 of 2)

7 - Tie Rod Bolt
8 - Mounting bracket

9 - Nut

PERFORMANCE ORDER

  1. Remove the key from the ignition.
  2. Remove the lever (1) release the bonnet.
  3. Remove the cover (2) to the left under the instrument panel, - replace broken locks.
  4. The properly labeled, disunite a socket (3).
  5. Remove the retaining band.
  6. Remove the screw (7) securing the tie rod.
  7. Loosen the nut (9) to release the locking clip (8).
  8. Remove the bolt (5) and remove the sensor output speed transmission (4), - if necessary, prepare a removable gasket. Remove the installation shortcut and drag it to the new sensor.
  9. Gently release the wiring from the sensor grommet (6) in the engine compartment.
  10. Installation is in the reverse order.
  11. Finally, clean the processor memory on-board self-diagnostic system.




« previos page
Removing and installing selector module (ESM)
next page »
Removal and installation of cooler ATF

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.