REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B6
		Operation and maintenance of car
		Engine
			Overview
			Mechanical (engine capacity of 1.6 liters)
				Removal and installation of the top casing of the engine
				Check the timing belt (4-cyl. Petrol engines of 1.6 liters)
				Removing Engine
				Engine installation
				Disassembly and assembly of the engine
				Removing and installing V-ribbed belt
				Removing and installing timing cover
				Replacing crankshaft oil seal on the side of the pulley
				A method of tightening the mounting bolt sprocket belt drive
				Dismantling and assemblage of pistons and rods
				Cylinder Head
				Checking the valve timing
				The timing
				Removing and installing the camshaft housing
				Removal and installation of the cylinder head
				Compression Test
				Repair the valve mechanism
				Checking the valve guides
				Replacing valve stem seals
			Lubrication system
			Cooling system
			Fuel Injection System
			The mechanical part (petrol engines of 2.0 liters)
			Lubrication system
			System ohlazhdeiya
			Fuel system
			Injection system
			System of release of gases otrabotavschih
			Ignition system
			The mechanical part (diesel engines of 2.0 liters)
			Lubrication system
			Cooling system
			Fuel system
			Turbocharging turbo running on exhaust
			The direct injection diesel
			Exhaust
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
		diagrams

printable version

Cylinder Head

Fig. 2.31. The components of the cylinder head 1 - a box for the high-voltage wires; 2 - a bolt 10 Nm; 3 - a bolt 10 Nm + to tighten on 1/4. (90 ?�); 4 - bolt 10 Nm; 5 - the air filter; 6 - the gauge of the Hall; 7 - O-ring; 8 - the holder; 9 - spacing bolts 6 Nm; 10 - a bolt of the cylinder head; 11 - roller lever; 12 - support member; 13 - adjusting pins; 14 - oil pressure sensor, 25 N ?� m; 15 - cylinder head; 16 - cylinder head gasket; 17 - guide bolt; 18 - eyelet for hanging; 19 - a bolt 20 Nm; 20 - Carter camshafts; 21 - a pusher plate; 22 - O-ring; 23 - high-pressure pump

NOTE

When installing a new cylinder head before installing the crankcase the camshaft is necessary Lubricate all the contact surfaces between the support elements, roller lever and cam-bed.

Included in repair kit plastic lining to protect the open valves are allowed to remove just prior to installation of the cylinder head.

When replacing the cylinder head and drain the old and fill with new coolant.

All support and work surfaces should be lubricated before installation works with engine oil.

Fig. 2.32. Check for a warped cylinder head

Check the curvature of the contact surface of cylinder head (Fig. 2.32).

The maximum allowable curvature of the contact surface of 0.05 mm

« previos page
Dismantling and assemblage of pistons and rods

next page »
Checking the valve timing