 printable version
Removal and installation of servo-leveling, headlamp manufacturer - Valeo
NOTE The figure below shows replacement of servo adjustment of the left headlight. Replacement servo the right headlight is similar. |
Withdrawal Remove the headlamp. Remove the cap 3.
2 Remove the retaining bolt and lift the housing 1 (Fig. 7.63).
Remove the pinion 1 of its mounting hole upwards (Fig. 7.64).
NOTE When removing the gear note not to lose the small O-ring. |
Disconnect the connector 2. Unlock servo-leveling 1 in the direction of B. Carefully push the ball head of the servomotor And back out of its guide.
Setting
| Fig. 7.66. Installing the servo-leveling to mount
|
Fully insert the servo motor 1-leveling in the unlocked position in its holder (Fig. 7.66). Lock the servo-leveling 1 by turning the stop in the direction B (Fig. 7.65). Carefully push the ball head of the servomotor And beginning ago. Finally, carefully insert the ball head in the direction of the servo motor mount 1 (Fig. 7.65).
NOTE At the same time move the reflector slightly backwards to facilitate the engagement of the ball head to the mount. |
Reconnect the connector 2 servo-leveling. Install the housing 1, 2 bolts securing it, and put on the cover 3 (Fig. 7.63).
NOTE When installing pay attention to the tight fit of the cap. Ingestion of water lights, headlamp may be spoiled. |
| 
