 printable version
Check headlight adjustment
Terms of checks and adjustments Tire pressure should be normal. Scattering glass must be clean and undamaged. Reflectors and lights are serviceable. The vehicle must be properly loaded. Relieve the spring shock absorbers. The car and the device to adjust the headlights must be on a level surface. Must be configured slope. On the stub of the headlamp contains degree tilt in "%". Headlights must be adjusted in accordance with this value. This parameter is a percentage calculated on the projection distance of 10 m. In terms of inclination of 1.0% obtained 10 cm. For vehicles with halogen headlights with manual override headlight aiming The wheel angle corrector headlamp must be in position -0. Load one passenger or 75 kg on the driver's seat in the vehicle without load (Wet weight). Curb Weight - is the weight of the vehicle ready for operation with a completely filled fuel tank (not less than 90%), including the weight of any additional equipment items (eg. Spare tire, tools, jack, fire extinguisher, etc.). If the fuel tank is filled with less than 90%, load the car follows Check the fuel level on the indicator. Determine the additional weight of the following table and therefore it load the trunk.
Table tank of fuel
Example If the tank is half full, then you need to put in the trunk of an additional 20 kg.
NOTE As the additional weight it is best to use a water-filled canister (5-liter canister with water weighs approximately 5 Kg). |
For vehicles with headlights with gas discharge lamps with correction dynamic headlight range control
NOTE In cars with the headlights with gas discharge lamps in front of each adjustable headlights should fault memory using the tester, clean it and set the basic setting the angle of the headlights. |
| 
