REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B6
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
			Overview
			Power supply system
			Lighting
				Removing the lights
				Installing lights
				Adjusting the headlights
				Replacing the lamp beam
				Replacing the lamp beam
				Replacing the parking light bulb
				Removal and installation of servo-leveling, headlamp manufacturer - Hella
				Removal and installation of servo-leveling, headlamp manufacturer - Valeo
				Check headlight adjustment
				Check headlight adjustment via vyverochnogo screen without adjusting the 15 ?�
				Adjusting headlamp with gas discharge lamps
				Adjusting the main headlights with halogen lamps
				Main Headlights with gas discharge lamps
				Replacing gas-discharge lamp
				Removing and installing front turn signal lamp
				Removing and installing lighting in the door mirrors to facilitate landing
				Removing and installing the rear light in the sidewall of the body
				Removing and installing light plate (sedan)
				Removing and installing the license plate light, station wagon (Variant)
				Removing and installing bonnet contact switch
				Removing and installing light switch
				Removal and installation of a regulator-leveling and dimmer buttons and instrument panel
				Removal and installation of a control lamp off the front passenger airbag
				Removal and installation of lighting the glove box
				Removal and installation of a control lamp central locking SAFE function
				Replacement of ceiling lighting front of the cabin
				Removing and installing center console switches
				Removing and installing the main fuse box
				Removal and installation of the switching unit on the left side of the engine compartment
				Removal and installation of the relay unit on the left side of the front panel
				General information on repair electricians of the car
				Repair wire CAN bus
				Broken wire with repair in two places
				Repair of contacts in the connector housing
				Mechanical locking connector housing
				Round contacts
				Flat contacts with asymmetrical locking tongues
		Body
		diagrams

printable version

Removing and installing center console switches

Removal and installation of the following elements is the same, so the description is only for one item.

NOTE

When removing and installing components that are in view (switches, covers, trim panels and so forth.), Cover the application site tools, wedge, screw driver and so on., The conventional tape.

Withdrawal

Turn the ignition and all electrical consumers and turn the key in the position 0 (pre-emphasis).

Fig. 7.108. Removing the panel

Remove the panel 1 (Fig. 7.108).

Disconnect plug connection.

Unlock retaining clips and remove the switch.

Setting

Installation is carried out in reverse order.

« previos page
Replacement of ceiling lighting front of the cabin

next page »
Removing and installing the main fuse box