 printable version
Replacing the oil seal on the side of the crankshaft vibration damper
NOTE If the plastic sealing flange, the gland can not be replaced individually - must be replaced by a sealing flange. |
Withdrawal Result a radiator framework in service position. Remove ribbed belt. Remove the vibration damper. For this secure vibration damper with a key to lock the T10069.
| Fig. 2.48. Setting the hook under the lip gland
|
Insert the hook T20143 / 1, as shown in Figure 2.48, working under the seal lip. Lean hook - T20143 / 1 - on flange, pry out the oil seal in the direction of the arrow and remove it.
Setting Remove the remaining oil on the toe of the crankshaft with a clean cloth. Push guide sleeve 1 (T10215 / 1) on the front of the toe of the crankshaft. Then gently 2 Push the gland over the guide sleeve as far as possible.
Press in the oil seal until it stops using the mandrel 3 (T10215 / 2). To do this, use the old retaining bolt 4 vibration damper (Fig. 2.49).
NOTE Fixing bolt vibration damper should be replaced. |
Tighten the fixing bolt with a torque wrench VAG 1601. Install vibration damper and lock key to lock the T10069. Tighten the new fixing bolt with a torque of 100 Nm + 1/4 turn (90 ?�). Install poly V-belt.
| 
