REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Transporter, Caravelle (1990 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Transporter / Caravelle
		Instructions
		Engine
		Coupling
		Transmission
		Suspension
		A steering
		Brakes
		Wheels and tires
		Body
			Total information
			Bumper
			A forward closing beam
			Bonnet
			Backdoor
			Tailgate
			The front door
			Sliding door
			Rear double doors
			Radiator grille
			A protective lath license plate light
			Mirrors
			Front seat
			The middle row of seats of salon
			The rear banquette seating
			Glovebox
			Heating System
				Inlets
				Motor heater
				Air deflectors
				Heating controller
				Ropes
				Additional heat exchanger
				Additional heating system on the model of "Caravel"
				Fault diagnosis of the heating system
		Electrical

Motor heater

Withdrawal

PERFORMANCE ORDER

1. Disconnect the earth cable (-) from the battery.
A warning This memory is erased anti-theft radio code. Do not disconnect the battery when the ignition is switched on. Otherwise, the control unit injection system fails.
2. Remove the inlets.
3. Check the ease of movement of the fan wheel in the installed state.
4. Remove the glovebox.
5. Remove right air duct (see. Fig. Arrangement of the heating system).
6. Remove the plug on the body.
	7. If the motor heater is not working at all levels, as a rule, defective preliminary resistance. In this case, replace the connecting plate, remove the screw (2).
8. press down the screwdriver locking tabs (4). Turn the motor heater clockwise to withdraw in the middle of the instrument panel and remove.
9. Remove the existing foreign objects from the air flow passage.

Setting

PERFORMANCE ORDER

1. Install and tighten the connection fee.

2. Install the motor heater, turn left and secure.

3. Connect the plug.

4. Connect the earth cable (-) and test the motor of the heater.

A warning

The battery connected only when the ignition is switched off, otherwise fail control unit injection system.

5. set the clock.

6. Enter in the anti-theft radio code (see. Subsection 10.19.11).

7. Install the air duct.

8. Install the inlets.

9. Install the glove box.

« previos page
Inlets