add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Design Features
Compression check in cylinders
Removal and installation of mudguards of the engine
Mount Replacement power unit
Installation of the piston of the first cylinder to TDC of the compression stroke
Removal, installation and Troubleshooting flywheel
Replacement parts Seal Engine
Cylinder Head
Removing and installing engine
Engine repair
Lubrication system
Cooling system
Exhaust
The power supply system of the engine
Design Features
Check the pressure in the fuel system of the engine
Reducing the pressure in the feed system
Removing and installing air cleaner, muffler and intake duct
Replacement of the fuel pump
Replacement of the fuel tank and the filler pipe
Checking and replacing the fuel pressure regulator
Removing and installing the fuel rail
Removal, installation and check of atomizers
Removing and installing throttle assembly
Check and replace the idle speed regulation
Adjustment and replacement of the throttle cable
Removal and installation of the accelerator pedal
The system EVAP
Exhaust gas recirculation
Transmission
Chassis
A steering
The brake system
Electrical
Body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Check and replace the idle speed regulation



Idling regulator located in the upper portion of the throttle device. It consists of a bipolar stepper motor and connected to the valve cone. At a signal from the motor control unit moves the valve, thereby changing the flow area of the air passage.
You will need: Phillips screwdriver with a blade tester.
1. Disconnect the harness from the controller (ignition off) by pushing its spring clip.
2. Turn on the ignition and measure the tester in voltmeter mode voltage between terminal blocks A and "weight" of the car.
3. Repeat the test for the other findings in turn blocks (B, C and D). Indications tester for the four measurements must be within 0,4-12 V.
4. Switch the tester in ohmmeter mode and measure the resistance between terminals A and B of the controller, and then between the terminals C and D. The resistance should be in the range of 40-80 ohms.
5. To replace the controller remove the two screws securing it to the throttle assembly ...
6. ... and remove the regulator from the opening of the throttle assembly.
7. Set the idling in the reverse order of removal.




« previos page
Removing and installing throttle assembly
next page »
Adjustment and replacement of the throttle cable

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.