printable version
Replacement of the fuel tank and the filler pipe
If fuel leaks from the tank is recommended to replace the tank. If the mesh is often clogged fuel pump, remove and rinse the tank. If found to flow through the junction of the upper and lower parts of the tank, you can place the solder (recommended in specialized shops). To do this, pour gasoline residues, rinse thoroughly and dry tank. Then the leak solder soldering. WARNINGS Plumbing can only be thoroughly washed and-dried tank containing no gasoline vapors, or soldering vapors can ignite. To flush the fuel tank use detergents "Lobomid" MS or ML. Then, to remove any residual detergent, rinse and steam the jet of hot water tank. Thoroughly dry tank. It is more convenient to shoot an empty tank, working on the lift, platforms or pit. To remove the remaining fuel remove elektrobenzonasos (see. "Replacement of the fuel pump") and pump out oil through the open hole in the tank. |
You will need: the keys "8", "12" combination pliers, flat-blade screwdriver. 2. Disconnect a wire from the plug "minus" of the storage battery. | | 3. Disconnect from the blast pipes and drain hose of the fuel pump by squeezing their catches. | 4. Disconnect the outlet pipe of the fuel vapor in the absorber, squeezing his retainers. |
| | 5. Squeeze the clamps and disconnect the harness connector of the fuel pump. | 6. Remove the parking brake cable from the holder located on the fuel tank in front of his ... |
| | 7. ... and right. | 8. Loosen the hose clip and disconnect the ventilation hose from the fitting of a fuel tank. |
| | 9. Loosen the hose clamp on the inlet pipe, pressing pliers bent his ears, then slide the hose clamp and disconnect the hose from the pipe of the fuel tank. | 10. Establish under the fuel tank support, remove the two screws on the bottom of the tank to the body in front of ... |
11. ... and back. 12. Remove the support and remove the tank from the vehicle.
HELPFUL ADVICE Remove the fuel tank with an assistant, because the tank is quite heavy and uncomfortable to hold the shape. |
13. Install the fuel tank in the reverse order of removal. 14. After joining the piping and wiring harness fuel pump fill the tank with petrol, start up the engine and check the tightness of all pipe connections.
If you need to remove the filler tube of the fuel tank, do the following. 1. Remove the right rear wheel and the vehicle on a suitable support. | | 2. Remove the four screws on the enclosure tube to the body ... | 3. ... and remove the cover. |
4. Remove the filler pipe hose and ventilation pipes on the fuel tank (see. Nos. 8 and 9 of this subsection). 5. Grab a side cutter (or cut with a knife) clamp hoses and pipes.
NOTE Clamp hoses and pipes disposable. When assembling fasten hoses and pipes a new clamp. |
| | 6. Open the door of the neck of the fuel tank filler tube and remove the plug from the neck. | 7. Remove the three screws on the inlet pipe to the side of the body ... |
| | 8. ... bolt bracket filler pipe to the bottom of the body ... | 9. ... and remove the filler tube assembly with a bracket and a ventilation hose. |
| | 10. If necessary, replace the fuel filler pipe with a screwdriver unclip retainer bracket ... | 11. ... and remove the bracket ... |
| | 12. ... remove the grommets from the lower ends of the filler pipe ... | 13. ... and the vent hose, and then install the removed parts to the new filler pipe. |
14. Install the filler tube of the fuel tank in the reverse order of removal.
|