printable version
Replacement lock the back door
You will need: a key TORX T40, Phillips screwdriver blade.
NOTE To remove the outer and inner knob is because disconnected from the traction drive lock installed on the door, it is very difficult. Comfortably furnished with locking rods and in turn to release the rod from the pens need their removal. |
| | 4. Remove the three screws securing the lock to the door panel. | 5. Remove the lock from the car, moving it through the technological hole in the door panel. |
| | 6. If you change the lock, unclip the plastic retainers in mind ... | 7. ... and detach the lock lever pull the inside handle lock actuator ... |
| | 8. ... and the draft from the outside handle. | 9. To remove the latch lock the door remove the two screws securing it to the front of the body ... |
10. ... and remove the clip with reinforcement plate. 11. Install the rear door lock and all the removed parts in reverse order of removal.
NOTE If necessary, adjust the clarity of moving latches locking the lock by loosening the screws of its fastening. |
|