REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
			Technical data
			The mechanism of the tilt steering column
			Steering transfer without power steering
			Tie Rod
			Check backlash steering wheel for vehicles with power steering
			Checking steering angle of front wheels
			Check torque pin of the spherical rod end
			Check of effort of the steering wheel for vehicles with power steering
			Checking the steering wheel return to its original position
			Check the fluid level
			Liquid replacement in a hydraulic drive the power steering
			Bleeding the hydraulic system of the power steering
			Checking the belt drive power steering pump
			Checking the fluid pressure in the hydraulic system
			Steering transfer of cars with power steering
			The power steering hoses
			Power steering pump
			Troubleshooting (steering without the amplifier)
			Troubleshooting (power steering)
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

printable version

Check of effort of the steering wheel for vehicles with power steering

PERFORMANCE ORDER

1. On the car standing on a firm, level surface, set the front wheels to straight-line motion.

2. Increase the engine speed to 1000 ^min -1.

A warning

After checking, leave the engine running at idle speed

3. Hook the dynamometer for a steering wheel spoke in a place the most remote from the center of the wheel. With the front wheels established for rectilinear movement, measure the force that must be applied to the steering wheel to turn the wheel left and right.

Force: 34.3 N

4. Make sure that when you turn the steering wheel does not require excessive force.

5. If the measured force is greater than the required value, carry out the following checks:

- Check for damage to the protective covers of the lower arm ball joints and tie rod;
- The torque that must be applied to crank pin of the spherical rod end;
- The torque that must be applied to crank pin of the spherical hinge of the bottom lever.

« previos page
Check torque pin of the spherical rod end

next page »
Checking the steering wheel return to its original position