 | The fuel system is under pressure even after the engine is switched off, therefore before a detachment of pipelines it is necessary to remove pressure in fuel system. |
 | 1. Remove the fuel pressure as follows. - Open the trunk and disconnect the connector from the fuel pump.
- Start up the engine and let it run until the stop associated with the lack of fuel in the fuel distribution line. As a result of actions taken to remove pressure in fuel system.
- Switch off the ignition.
- Disconnect "weight" from the storage battery.
- Connect the fuel pump.
|
2. Remove the bolt that secures the fuel line to the fuel filter. | To eliminate the spray of fuel close the connection point of the fuel system and a clean cloth, being careful, gently disconnect the piping. |
 | 3. Install adapter 09353-3800 connected with him 09353-24100 gauge between the fuel supply pipes and tighten the bolts torque adapter recommended specification. Torque: 25-35 N ??? m |
4. Connect a wire of "weight" to the battery.
5. Activate the fuel pump, the battery voltage is applied to the connector of the pump, and make sure there are no fuel leaks.
6. Start the engine and let it run at idle.  | 7. Remove the vacuum hose from the pressure regulator, and close the end of the hose. Measure the fuel pressure at idle. Fuel pressure: 320-340 kPa |
| | 8. Measure the fuel pressure after the connection of the vacuum hose with a pressure regulator. Fuel pressure: 255 kPa |
9. If the pressure is less than the required check fuel pump and pressure regulator.
10. Turn the engine off and after 5 minutes check the pressure in the fuel system. If the pressure is less than the required check the fuel pump, pressure regulator and fuel injectors.
11. Reduce the pressure in the fuel line.
12. Remove the pressure gauge and adapter. | To eliminate the spray of fuel close the connection point of the fuel system and a clean cloth, being careful, gently disconnect the piping. |
13. Replace the O-ring at the end of the hose.
14. Connect the fuel hose to the backbone.
15. Check for fuel leaks. |
