 printable version
Front bumper
Front and rear bumpers are made up of three parts: the bumper cover, foam energy absorber and the bumper amplifier. Pad is made of polypropylene. The foam energy absorber made of polystyrene foam. Power bumper is made of durable polypropylene fibers. The foam energy absorber is located between the bumper and the amplifier. Check | 1. Visually check the condition of lining the front bumper for damage and check the reliability of the bumper.
2. Check the front bumper to the absence of foreign objects in it. |
|
Withdrawal |  | 1. Remove the headlamp. |
 | 2. Remove the grille. |
 | 3. Remove the bumper cover. - Disconnect the right fog lamp.
- Remove one connector and remove the two screws on the upper right side of the bumper.
- Repeat this procedure on the left side.
|
 | - Remove the two screws from the front of the bumper cover.
- Turn out one bolt from the left side of the bumper.
- Repeat these operations on the right side.
- Remove the four connector from the cover.
|
 | 4. Remove the foam energy absorber and amplifier. |
 | - Remove the two nuts on the left side of the rear bumper.
- Repeat these operations on the right side.
|
|
|
Setting | Install the front bumper in the reverse order of removal. Torque: 19-28 N ??? m |
|
| 
