REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz M-Class (W163, 1997 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W163
		Introduction
		Controls and receptions of safe operation
		Current care and maintenance
		Engine
		System of cooling, heating and air conditioner
		The power supply system and exhaust
			The power supply system of petrol engines
			The power supply system of diesel engines
			Exhaust systems and reduce emissions
				Removing and installing exhaust system
				Replacing the front section of the exhaust system on petrol models
				Removing and installing catalytic converters on diesel models
				Removing and installing Lambda probe
				Removing and installing valve EGR, - M112 / 113
				Removal and installation of cooler EGR, - diesel models
				Removal and installation of an air pump - M112 / 113
				Removal and installation of a coal adsorber - petrol models
				Removal and installation of the expansion tank accumulation of fuel vapors, - properly equipped models 163.113 / 154/128
		Systems of an electric motor
		Manual box of a gear change
		The transmission automatically processed
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric

Removal and installation of the expansion tank accumulation of fuel vapors, - properly equipped models 163.113 / 154/128

Details of the expansion tank accumulation of fuel vapors models 163,113, 163,154 and 163,128 corresponding complete

PERFORMANCE ORDER

Details of the installation of the expansion tank accumulation of fuel vapors in the corresponding models of equipment shown in the illustrations, which include all the links in the text.
Remove the filler cap of the fuel tank (1).
Turn the loop (3) in the closed position.
Remove the bolts (4).
Remove the trim panel rack C.
Separate from the filler neck (6) vent line (5).
Remove the bolts (7) the bracket (8) filler cap (5).
Remove the lock body parts (9).
Remove the retaining screw (10) and pull the expansion tank (11) forward.
Loosen planting rubber sealing element (12) of the neck (6) on the floor of the car.
Remove the filler neck assembly from the mounting bracket from the counter C.
Remove the rack from the expansion tank (11).
Installation is in the reverse order - when installing the lock (9), make sure that the wiring was held under the arm (8), the bolt (2) securing the hinges before screwing lubricate locking sealant. Track correctness of adjusting the filler cap (1).