REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
			Specifications
			The active warning system Maturity planned TO (ASSYST)
			The routine maintenance schedule
			General information about the settings,
			Check fluid level, leakage control
			Checking the condition of tires and pressure in them, the designation of tires and wheel rims, wheel rotation
			Replacing the motor oil and oil filter
			Check the brake system
			Check the power supply system, replacement of the fuel filter
			Check and replacement of hoses of an impellent compartment, localization of leaks
			Checking the multirebernyh accessory drive belt
			Check the functioning of the cooling system and frost coolant fluid replacement
			Checking the exhaust system
			Replacement ATF and filter AT
			Visual check of tightness automatic transmission
			Checking the suspension components and steering
			Checking the status of anther drive shafts
			Check the air conditioning system
			Grease limiters door locks and cylinders
			Visual inspection of safety belts and airbag modules
			Verifying the headlights and horn
			Check and replace wiper blades
			Checking the status of the battery, care it and gymnastics
			Replacing the cabin filter
			Replacing the drive fluid differential lock
			Replacing brake fluid
			Check and replacement of spark plugs, check the status of high-voltage wires (petrol models)
			Replacing the glow plugs (diesel models)
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric
		Wiring

printable version

Visual check of tightness automatic transmission

The oil in the AT change is not required during the entire period of operation.

The most likely sites of leaks ATF include:

The plane of the joint cylinder and AT (crankshaft rear oil seal);
Connection of the drive shaft to the gearbox;
Drain plug;
The filler tube.

PERFORMANCE ORDER

Clean the sump AT.
Possible leaks sprinkle a thin layer of chalk or talc.
Take a test drive at a distance of about 30 kilometers.
Raise the vehicle on a lift or over a viewing hole and oil spills for the leak oil.
Eliminate the leak and fill the oil in the gearbox.

« previos page
Replacement ATF and filter AT

next page »
Checking the suspension components and steering