 printable version
Check and replacement of brake pads
Check  | Visual inspection of the condition of the brake pads |
| - Visual assessment of the pad can be made through an opening in the rim, and a viewing window to remove the brake mechanism (arrow). In parallel, it makes sense to evaluate the condition of the brake disc.
- If necessary, prepare interchangeable components.
|
|
Refitting  | Brake pads should be replaced at the same time set for both wheels on one axle! |
Brakes with calipers fixed type Details of the brake pads in the caliper of the fixed type (1 of 2) Details of the brake pads in the caliper of the fixed type (2 of 2)  | | |
| - Release of contact pads (52) wear indicator (S10 / 1 and S10 / 2).
- With the punch (035), remove the retaining pin (41).
- Remove the steel spring plate (41a).
- With the help of a stripper (070) Remove the brake pads (43).
- Separate from the pads wear friction pads (S10 / 1 and S10 / 2).
 | Faulty sensors must be replaced. |
- With the help of a special device (031) press the piston (47) of the wheel cylinder, - pre-evacuate some of the liquid from the tank, providing a certain stock volume level on the rise.
| The opposite pair of pistons to be locked by pushing with wooden struts. |
- Operating in a similar manner, press the opposite pistons, - try not to bend thermofilter.
- Strip guide surfaces slide with a special brush (030).
- Installation is in the reverse order - before landing pad lightly grease their side surfaces (arrows) with a special paste. Make sure that the retaining finger was planted in the saddle all the way - again, use a knockout.
- Finally, check the brake fluid level in the tank, if necessary, make appropriate adjustment.
|
|
Brakes with calipers floating type Details of the brake pads in the caliper floating type (rear axle)
| - Remove from the anchor bracket (1) the bolts (3).
- Without disconnecting the brake hose, remove the caliper (2).
- Remove the brake pads (4).
- Press the pistons into the cylinders - make sure that the liquid does not embossed over the edge of the tank GTZ, if necessary, pump out the excess.
- Strip support with a special brush.
- Installation is in the reverse order. Be sure to check and, if necessary, adjust the level of the liquid in the tank GTZ.
|
|
|
