REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
			Specifications
			Front suspension
			Rear suspension
			Steering
				general information
				Check the steering pump pressure
				Check and adjustment of the hydraulic stop
				Adjusting the steering shaft
				Assessment of components of the steering gear
				Removing and installing steering wheel
				Removal and installation of the contact cable drum steering wheel
				Removing and installing steering angle sensor wheel
				Removal and installation of the mechanism of the electronic steering column lock
				Removing and installing steering column with electric adjustment
				Removing and installing the steering pump
				Removing and installing power steering fluid cooling line
				Removal and installation of the steering mechanism
				The design of the steering mechanism
			The suspension geometry
		Body
		Onboard electric
		Wiring

Removal and installation of the mechanism of the electronic steering column lock

Details of the installation of an electronic steering column lock (ELV)


37m - Fixing bolt 37P - Socket 71 - Sleeve column	N26 / 5 - electronic lock control module

PERFORMANCE ORDER

On models corresponding complete set (code ET2) activate the service mode of the emergency call TELE AID (see. Section Activate / deactivate the service mode of the emergency call AID TELE). Remove the lower section of the instrument panel trim on the driver's side of the vehicle (see chap. Body). At a corresponding complete set remove the knee-stop (see chap. Body). Expand the side sample and remove the retaining bolt (37m). Release the lock of the electronic control unit (N26 / 5) of the sleeve of the steering column (71)
Turn on the auxiliary battery and connect it to a standard battery, then disconnect the negative cable last. 7 - Auxiliary battery 8 - terminal positive wire module 9 - negative terminal wire module W10 - Ground Battery
Disconnect the connector (37P). Installation is in the reverse order. With proper configuration, deactivate the service mode of TELE AID. Finally, clean the processor memory on-board self-diagnostic system (see chap. Systems of an electric motor).