REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
			General information and safety measures
			The power supply system of petrol engines
			The power supply system of diesel engines
				Overview
				Checks fuel injection system
				Service components of an inlet air path
				Service components of the throttle
				Emptying the fuel tank
				Removal and installation of the gauge of a stock of fuel
				Removal of air from a contour of low pressure fuel path
				Removal and installation of the fuel pump prior
				Removal and installation of the fuel pump (high pressure pump)
				Removal and installation of a fuel distributive highway and injectors
				Removal and installation of the pressure sensor in the fuel line
				Removal and installation of the valve, the fuel pressure regulator
				Removal and installation of the valve assembly
				Removing and installing fuel cooler
				Removal and installation of low-temperature cooler
				Removing and installing fuel injection control module
				Removing and installing fuel tank
			Exhaust systems and reduce emissions
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric
		Wiring

printable version

Removal and installation of the pressure sensor in the fuel line

Models 463.323 (M612)

Details of the installation of the pressure sensor in the fuel distribution manifold (M612)

21 - Highway
B4 / 6 - Fuel pressure sensor

PERFORMANCE ORDER
Remove the trim panel of the cylinder head cover.
Disconnect the wiring and remove the pressure sensor (B4 / 6), the second key choke hold on the highway (21).
Installation is in the reverse order. Finally, clean the memory module on-board self-test (see chap. Systems of an electric motor).

Models 463.333 (M628)

Details of the installation of the pressure sensor in the fuel distribution manifold (M628)


1 - Vacuum line 2 - Support bracket	21/7 - Manifold B4 / 6 - Fuel pressure sensor

PERFORMANCE ORDER

Remove the air cleaner (see. Section Service Component inlet air path).
Release of the support bracket (2) and move aside the vacuum line (1).
Disconnect the wiring and remove the pressure sensor (B4 / 6).
Installation is in the reverse order. Finally, clean the memory module on-board self-test (see chap. Systems of an electric motor).

« previos page
Removal and installation of a fuel distributive highway and injectors

next page »
Removal and installation of the valve, the fuel pressure regulator