add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Touareg (from 2003 to 2006, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Touareg
Home
 
Volkswagen
Touareg
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
Exterior body parts
Removing and installing bonnet
Removing the gas stop
Release of gas from the gas stop
Removing and installing insulation
Removing and installing bonnet
Adjust the bonnet
Disconnecting the flexible cable
Removing and installing tailgate
Adjusting the tailgate with the hinge
Adjusting lock loop
Removal and installation of a gas cap lock
Removal and installation of a gas cap lock
Removal and installation of elements of the locking and unlocking doors
Removing and installing lock the tailgate
Removing and installing lock loop soft closing
Removal and installation of the motor opening the tailgate
Removing and installing rear spoiler
Removal and installation of elements of the locking and unlocking the fuel filler flap
Adjusting the door
Removal and installation of the lock cylinder housing
Removal and installation of door handles
Removing and installing door lock
Adjusting the back door
Removal and installation of the lock cylinder housing
Lifting sunroof with glass panel
Removing the glass panel lifting and sliding sunroof
Check the parallel progress of the glass panel
Fit seal the hatch panel
Removing sunglass
Removal and installation of facing of the front bumper
Removing and installing rear bumper fascia
diagrams
 


Hit Counter by Digits


print page printable version

Adjusting the back door



To properly adjust the door, loosen the hinge of the door at the front. Other measures, such as lift-up doors, are ineffective. On the subsequent load again door gives way.
For this purpose use the key to adjust the door with the attachment 3320 3320/2.
If necessary, unscrew the top door hinge at the front in the inside, you can use the nozzle adapter 3320/1.
To do this, remove the B-pillar trim and door sills.
When installing a new cladding door frame mounted units not affected.

Adjusting the back door
Fig. 8.40. Adjusting the back door


The rear edge of the door cladding is set higher by about 1 mm relative to the rear door, the size of a (Fig. 8.40).
After installing the door frame mounted units lowered to 1 mm.




« previos page
Removing and installing door lock
next page »
Removal and installation of the lock cylinder housing

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.