 | 1. Loosen the bolts (1) Tension bracket (A) and the generator by about one turn (B - Tension nut). |
A warning  The generator must be easily movable. This means that it should lean towards under its own weight.
|
| 2. Turn the tension nut (B) left by loosening and removing the V-belt. |
| 3. Fit the V-belt. |
| 4. Turn the tension nut to the right and pull the V-belt. A belt will pull correctly if the tension of the belt is made of old torque 4 Nm applied to the tension nut for a new belt - 8 Nm. Hold the nut in this position, tighten the screw securing the 1 to 35 Nm. |
A warning To tighten the tension nut torque wrench is required to the size of the nozzle cap 22 mm. You can also use the open-end nozzle HAZET 2593-22 in conjunction with a torque wrench and strongly curved ring spanner 13 mm.
|
| 5. Tighten the screws "on the support generator" to 35 Nm, and the "Tension eye on the cylinder head" moment of 20 Nm. |
