printable version
Removal and installation of the electronic control unit an additional system of passive safety
You will need: all the tools necessary to remove the lining of the tunnel floor, and the key TORX T30. 1. Disconnect a wire from the plug "minus" of the storage battery. | | 3. Pull the lever pad harness ECU ... | 4. ... and disconnect the connector from the unit. |
| | 5. Remove the three screws on the control unit to the bottom of the body ... | 6. ... and remove the block. |
NOTE Note the labeling of the control unit, to purchase a replacement unit with the same label. |
7. Install the electronic control system of passive safety and all the removed parts in reverse order of removal. The arrow on the block must point forward.
|