REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Chevrolet
	Lanos
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
		Body
			Design Features
			Possible malfunctions of the body, their causes and remedies
			Removing, dismantling and installation of bumpers
			Removing and installing radiator grille
			Removal and installation of mudguards of wheels and Lockers
			Removal and installation of a forward wing
			Removal and installation of a lattice box vozduhopritoka
			Hood
			Door
			The trunk lid
			Manhole cover fuel tank filler pipe
			Seats
			Removal and installation of facing of a tunnel floor
			Restraint System (SRS)
				Design Features
				Removing and installing driver's airbag
				Replacing the front seat belt
				Replacement of a back seat belt
				Removal and installation of the electronic control unit an additional system of passive safety
			Rear view mirrors
			Dashboard
			Heater and air conditioning
			Interior fittings
			Removal and installation of facing of salon
			Removal and installation of facing the boot
			Windscreen wiper
			Replacement of the fixed glass body
			Removing and installing the attachment flanges of the battery
			Care body
		Wheels and tires
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Tips novice mechanic
		Applications
		Diagrams

printable version

Removing and installing driver's airbag

Driver's airbag have to shoot in the repair of steering components and electrical equipment. Therefore, the process of removal and installation described in this manual. However, to avoid injury to strictly adhere to the recommended sequence of work.

You will need: a key TORX T50, flat-blade screwdriver.

1. Disconnect a wire from the plug "minus" of the storage battery.

WARNINGS

Attempting to remove the airbag module without disconnecting the battery can cause unexpected triggering airbags.

Proceed to the following operations to remove the airbag is possible only after the full discharge of the capacitor activator. To discharge the capacitor, you must wait at least 15 minutes after disconnecting the wires from the plug "minus" of the storage battery.

Do not disassemble the airbag module.

Do not drop the airbag module and hit him water, grease or oil.

Do not expose the air bag module temperature above 95 ?� C.


2. Having hooked a screw-driver, remove the plug on the wall to the left of the steering wheel ...	3. ... and right.


4. Remove the screws securing the airbag to the steering wheel hub on the left ...	5. ... and right.


6. Gently lift the airbag module ...	7. ... take him from the steering wheel by pressing the lock, Disconnect switches audio signals ...


8. ... unbuckle the harness retainer pads airbags ...	... 9. Disconnect the air bag module ...

10. ... and remove airbag module.

11. Install the air bag in the reverse order of removal.

« previos page
Design Features

next page »
Replacing the front seat belt