 printable version
Baby seat
When transporting children in a car, always put them in the back seat and buckle, in order to minimize the risk of injury in the event of a road accident, sudden braking or turning. Statistics of traffic accidents shows that children held device properly undergo less danger in the rear seat than in the front. Older children should be available in the car wearing seat belts. Child seat is manufactured in accordance with the instructions of the manufacturer of this device.
A warning  Child seat should be installed in the back seat. A baby "cradle" or child seat in the front seat is not allowed. If in the case of a traffic accident triggered the airbag front passenger, it can seriously injure an infant or child seated in the cradle or child seat.
Children who have small children seats should sit in the back seat and fasten the lap-shoulder combination belt.
Always make sure that the lap-shoulder shoulder of the side seat belt was located in the middle of the shoulder and does not touch the neck. Moving the child closer to the center of the vehicle can contribute to a better belt installation. Shoulder cingulate-side shoulder belt and the lap belt is the central rear seat should always be positioned as low as possible and if possible more densely.
If you can not correctly secured child seat safety belt, it is recommended to use a pad under the child seat to increase the ride height of the child so that it was possible to correct a child of seat belt.
Do not let the child standing on the seat, or is on the hands.
Use of child safety seats, which are attached to the seat back is unacceptable; such devices do not provide the necessary security in the event of a traffic accident.
Holding the baby in her arms while driving is unacceptable, the child could be seriously or even fatally injured in the event of a traffic accident or sudden braking. Your hands can not replace a child seat, even if you are wearing a seat belt.
Seat belt pretensioners (vehicles without airbags) In normal cases, the seat belt pre-tensioners work in the same way as the seat belt inertia lock mechanism. (The belt is locked in the position in which it is in the case of heavy braking of the vehicle. It will also be blocked if you try to pull it too sharply from the retractor). However, at the time of the collision pretensioner instantly retracts the seat belt to clearly indicate the passenger seat belt and pick up the slack of the belt.
A warning During operation pretensioner allocated a small amount of smoke and there is a strong cotton. This cotton is normal and not dangerous.
Seat belt pretensioners is specially designed to operate only at medium or high impact strength and only once.
In the case of triggering seatbelt pre-tensioners do not try to replace it yourself. It should be performed only by an authorized Hyundai dealer.
Seat belt pretensioners vehicles with airbags
Your vehicle is equipped with Hyundai seatbelt pre-tensioners for driver and front passenger. The appointment of such a belt is to ensure accurate fixing passenger in some cases in a frontal impact. The belt pretensioner can work individually as well as together with the airbags in a frontal impact of sufficient force.
| Front seat belts with pretensioners |
Safety belt pre-tensioners works in the same way as the seat belt retractor inertial automatic locking. In the event of a sudden stop or when the passenger tries to pull the belt too quickly retracting mechanism automatically lock the seat belt. However, in the frontal impact medium or large power pretensioner instantly retracts the seat belt.
| Location of the system seatbelt pre-tensioners:
1 - a control lamp SRS;
2 - pretensioner assembly;
3 - ECU SRS. |
A warning To achieve maximum efficiency seatbelt pre-tensioners: the belt must be properly fastened; belt should be properly adjusted.
Seat belts with pretensioners driver and front passenger are activated in a frontal impact of sufficient force. Seat belt pretensioners may work individually as well as together with the airbags in a frontal impact of sufficient force. Seat belt pretensioners during a severe frontal impact, even if the seat belt is not fastened.
During operation pretensioners allocated a small amount of smoke and there is a strong cotton. These phenomena are normal and not dangerous.
Despite the fact that this smoke is not toxic, it should not breathe because it can cause irritation, coughing or choking if you inhale a long time. After tripping pretensioners wash your face and hands.
Because the sensor that activates the SRS airbags connected to the circuit pretensioners, the SRS warning lamp in the instrument cluster will blink for 6 seconds after the ignition key is turned to "ON" (On.) Or "ACC", after which it should go.
If the seat belt is not working properly, the test lamp will be lit, even if the SRS air bag system is in good condition.
You should immediately seek to verify the authorized dealer Hyundai, if the ignition key is turned to "ON" (On.) Or "ACC", the control lamp of additional system of passive safety SRS (airbags) does not illuminate, does not go out after about 6 or lights up while driving.
Seat belt pretensioners are designed for single use only. After the seat belt worked, they no longer worked. All belts must be replaced after a traffic accident, regardless of the type of belt.
After tripping pretensioner assembly module of some parts will be hot. Do not touch them after firing pretensioner for a few minutes.
Do not attempt to test or replace the mechanisms of seat belts with pretensioners. It must necessarily be made the official dealer of Hyundai.
Do not strike the pretensioner assembly.
Do not attempt to service or repair the system seatbelt pre-tensioners.
Improper use of the seat belts with pretensioners assembly, failure to comply with prohibitions on strikes, change, verification and replacement, maintenance or repair of safety belts with pre-assembly may result in malfunction or triggered belt straps and serious injuries.
Always wear your seat belt before driving.
|
