REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes (ABS)
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Brake pedal
			Replacing the front brake pads
			Caliper front brake
			The main brake cylinder
			Replacing brake pads on the rear drum brakes
			Replacing the working brake cylinder
			Parking brake
			Hydraulic block HECU ABS
			Wheel speed sensor
			Troubleshooting
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Hydraulic block HECU ABS

Setting

PERFORMANCE ORDER

	1. Disconnect the brake pipes from the block HECU.
2. Remove the bracket bolts and remove the block HECU with bracket.
	A warning Do not disassemble the hydraulic block HECU. HECU transportation unit should be carried out in a vertical position with the holes block closed with suitable plugs, as brake fluid should not be merged with the unit.
	3. Disconnect the electrical connector block HECU.

Setting

PERFORMANCE ORDER

1. Installation is spent to sequences, return to removal.

2. Tighten the bolts and nuts of the modulator brake pipe required torques.

Tightening torques:
Bolt block HECU: 8-10 N ??? m
Connecting the brake pipe nuts: 13-17 N ??? m

« previos page
Parking brake