REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes (ABS)
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Brake pedal
			Replacing the front brake pads
			Caliper front brake
			The main brake cylinder
			Replacing brake pads on the rear drum brakes
			Replacing the working brake cylinder
			Parking brake
			Hydraulic block HECU ABS
			Wheel speed sensor
			Troubleshooting
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Wheel speed sensor

1 - a rotor;

2 - the front wheel speed sensor, 8-9.5 N ??? m;

3 - the rear wheel speed sensor, 15,5-16,5 N ??? m.

Withdrawal

The front wheel speed sensor

PERFORMANCE ORDER

Remove the bolt and remove the front wheel speed sensor after disconnecting.

Rear wheel speed sensor

PERFORMANCE ORDER

1. Remove the rear seat cushion.
2. Remove the C-pillar trim.
	3. Remove the rear wheel.
	4. Remove the rear wheel speed sensor after disconnecting.

Check

PERFORMANCE ORDER

	1. Measure the resistance of the wheel speed sensor. Resistance: Front sensor: 1275-1495 Ohm The back gauge: 1275-1495 Ohm
	2. Install the wheel speed sensor on the vehicle and connecting a voltmeter to the terminals of the sensor, measure the voltage generated by the sensor when the wheel rotates.
A warning Set the voltmeter to measure AC voltage.