REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes (ABS)
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Brake pedal
			Replacing the front brake pads
			Caliper front brake
			The main brake cylinder
			Replacing brake pads on the rear drum brakes
			Replacing the working brake cylinder
			Parking brake
			Hydraulic block HECU ABS
			Wheel speed sensor
			Troubleshooting
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Parking brake

1 - the parking brake lever;
2 - an adjusting nut;

3 - the parking brake cable.

Withdrawal

PERFORMANCE ORDER

1. Remove the rear console.
	2. Turn the adjusting nut and remove the parking brake cable.
3. Remove parking brake switch.
4. Remove the parking brake lever.
5. Remove the wheel.
6. Remove the brake drum.
7. Remove the brake pads.
	8. Disconnect the parking brake cable from the lever on the brake pads.
	9. Remove the clamp securing the parking brake cable sheath to a brake board.
10. Remove the rear seat cushion.
	11. Loosen the clamp on the parking brake cable and remove it from the vehicle.

Check

PERFORMANCE ORDER

1. Check the operation of the parking brake switch.

2. Check the parking brake lever ratchet for wear.

3. Make sure the parking brake cable for wear or damage.

Setting

PERFORMANCE ORDER

	1. Check the markings on the left and right parking brake cable and install in its place.
	2. Move the parking brake lever on the brake pad all the way back and install spring.
	3. Install the sealing ring in the direction shown in the figure.
4. Apply the recommended grease the ratchet and pawl ratchet parking brake lever. Recommended lubricant: SAE J310, NLGI ?��2
	5. After installation, adjust the compensator move the parking brake lever.