 printable version
Replacing the front brake pads
Caliper front brake 1 - the brake pads;
2 - dust cover;
3 - the piston;
4 - O-ring;
5 - a support to the cylinder;
6 - a protective cover;
7 - a bolt sleeve, 22-32 N ??? m;
8 - bleeder valve;
9 - Dust Cap;
10 - a hollow bolt to 25-30 N ??? m;
11 - the brake hose; | 12 - washer;
13 - a protective cover;
14 - a directing finger, 35-45 N ??? m;
15 - a bolt of fastening of a support, 65-75 N ??? m;
16 - the fastening element;
17 - the plug;
18 - a protective cover;
19 - a lining;
20 - a spring;
21 - a lining. |
Withdrawal
| PERFORMANCE ORDER | | 1. Remove the lower bolt, lift up the support and secure it with wire. |  | 2. Remove the brake pads. |
A warning  Do not push the brake pedal after removing the brake pads.
|
|
Check
| PERFORMANCE ORDER | 1. Check brake pads for wear and oil contamination and, if necessary, replace them.
The thickness of the brake linings:
Par: 90 mm
The minimum allowable: 2.0 mm |
A warning Always replace all the pads on the same axle of a vehicle, even if only one shoe is worn. If the brake pads will be repeatedly established, before removal they are necessary for marking.
|  | 2. Check the brake linings for damage. |
|
Setting
| PERFORMANCE ORDER | | 1. Set the clamps of brake pads. |  | 2. Install the brake pads on the brake pads every time. |
A warning Brake pads wear sensor, set by the piston.
|  | 3. The special tool 09581-11000 press the piston into the cylinder support. |  | 4. Install the new brake pads. |
A warning Never apply grease to the brake disc and brake pads.
|  | 5. Replace the bolt and tighten it to torque. Torque: 22-32 N ??? m |
|
|
