REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes (ABS)
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Brake pedal
			Replacing the front brake pads
			Caliper front brake
			The main brake cylinder
			Replacing brake pads on the rear drum brakes
			Replacing the working brake cylinder
			Parking brake
			Hydraulic block HECU ABS
			Wheel speed sensor
			Troubleshooting
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Vacuum brake booster

1 - a vacuum hose;
2 - a clip;
3 - pin head and the cotter pin hole;
4 - a nut, 8-12 N ??? m;

5 - spacer spacer;
6 - a lining;
7 - the vacuum brake booster.

Withdrawal

PERFORMANCE ORDER

1. Disconnect the brake pipes from the master cylinder.
	2. Remove the brake master cylinder.
A warning The brake liquid dissolves a paint, plastic and wire insulation, so if you accidentally hit fluid on the paintwork of a vehicle or its components, rinse with plenty of water.
3. Disconnect the vacuum hose from the vacuum brake booster.
4. In the car, remove the spring pin and remove the pin with a head and a hole for the pin.
5. Remove the brake light switch.
	6. Remove the four nuts of the vacuum brake booster.
7. Remove the vacuum brake booster.

Setting

PERFORMANCE ORDER

1. Set the brake servo with a new seal on the bulkhead and secure with four nuts. Torque: 8-12 N ??? m
2. Connect the traction brake pedal and set the pin with a head and an aperture under the pin and secure it with a new spring cotter pin.
3. Install the brake master cylinder to the brake servo and secure the nuts.
4. From the engine compartment, connect the vacuum hose to the brake servo.
5. Connect the brake pipes and tighten the nuts connecting tubes.
6. Fill popolnitelny tank of brake system with brake fluid. Remove air from the hydraulic circuit brake system.
7. Check for leaks of brake fluid.
8. Check and, if necessary, adjust the height of installation of a pedal and brake pedal free wheeling.
	9. After installation, apply grease to the contact point of the brake pedal and pull.