| 1. Remove the carburetor. |
| 2. Secure the carburetor in a vise jaws shut with a soft material, in this case should be open access to the fuel mixture adjustment screw (MAS). |
 | 3. Drill a hole diameter of 2 mm in the central hole for the screw adjustment of fuel mixture (MAS), after which the ream drill holes 3 mm in diameter. |
| 4. Insert a drift into the drilled hole and knock out the cork. |
| 5. Install the carburetor on the engine. |
| 6. Start the engine and warm it up to the coolant temperature 80-95 ?� C. |
Terms adjusting
Lights, electric radiator fan and all electrical consumers must be switched off, and the transmission should be set to the neutral position. |
| 7. Take a trip by car for 5 minutes at a speed of 48 km / h or more than 5 to increase the engine speed up 2000-3000min -1. |
| 8. Then allow the engine to idle for 2 minutes. |
| 9. Adjust the CO content and idle speed by turning the adjusting screw idle speed (SAS-1) and the screw of adjustment of quality of a fuel mix (MAS). CO content at the frequency of idling: 2,0 ?� 0,25%
The idle speed of the engine 1.3 liter with manual transmission: 850 ?� 100 min -1 |
 | 10. Install the plug, closing access to the screw of adjustment of quality of a fuel mix. |
