 printable version
Oil change the transfer case (models 4WD) (every 48 000 km (30,000 miles) or every two years)
| - Take a car trip length of at least 25 km (15 miles) to warm up the oil transfer box to normal operating temperature. If the vehicle is equipped with four-wheel drive, it is desirable to produce heating oil mode 4WD. During the trip, use all the gears, including reverse. This will ensure sufficient heating oil to smooth flows out of the box.
- Poddomkratte car and establish it on props.
- Remove the fill plug the transfer case (see.
- From the bottom of the box, remove the crankcase drain plug - it will provide a guarantee of unhindered oil drain.
 | - To remove the drain plug the transfer case, use the spanner wrench.
|
- Thoroughly clean the drain plug and after complete emptying of the box, screw it into place, tighten with demanded effort.
- Pour the oil into a box of the desired variety in such a way that it turned out to be flush with the surface of the lower edge of the filler hole.
- Replace and tighten the filler / level plug.
- Lower the car to the ground and after a brief, a few kilometers away, a trip, then recheck the oil level in the transfer case. Often, when this is required to produce a small topping.
|
|
|
