 | Before adjusting the throttle position sensor to adjust the speed of the crankshaft of the engine idling |
 | 1. Unplug the connector from the throttle position sensor.
|
 | 2. A jumper to connect additional probes of the voltmeter to terminals 1 and 2 of the connector throttle position sensor. |
 | 3. Insert the probe thickness of 0.65 mm between the screw adjusting the speed of the crankshaft of the engine idling (SAS)
and the throttle lever. |
4. Loosen the screws securing the throttle position sensor and turn the sensor housing to the stop anti-clockwise.
5. In this state, check that there is conduction between terminals 1 and 2.  | 6. Slowly turn the throttle position sensor clockwise to the point where there is continuity between terminals 1 and 2, and tighten the bolt of the throttle position sensor. |
7. Connect to the throttle position sensor.
8. Connect the scanner to the diagnostic socket in the fuse box.
9. In the absence of the scanner, connect a voltmeter to terminals 2 and 3 of the connector throttle position sensor. | Do not disconnect the connector from the throttle position sensor. For accurate measurements using a digital voltmeter. |
10. Switch on the ignition.
| Do not start the engine. |
11. Check the output voltage of the throttle position sensor. The output voltage of the throttle position sensor: 250-800 mV
12. If the output voltage of the throttle position sensor is not equal to the present specification, check the throttle position sensor.
13. Remove the dipstick.  | 14. Switch off the ignition. |
| 
