add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Magentis / Optima (2000 release)
general info. full specifications. diagnostics. hints. tips. tricks
 Kia Magentis
Home
 
Kia
Magentis
Engines
Lubrication System
Cooling system
The control and toxicity
Fuel system
Technical data
Multi-point fuel injection (MFI)
Verification system of injection MFI
The control lamp fault (MIL)
Diagnostic trouble codes
The coolant temperature sensor (ECT)
The gauge of absolute pressure in an inlet collector (MAF) with the IAT
Meter of air (MAF)
The temperature sensor of air entering the engine (IAT)
Throttle position (TP)
The modulator control the speed of the crankshaft of the engine idling
The heated oxygen sensor (HO2S)
Camshaft position sensor (CMP)
Sensor crank angle (CKP)
Fuel injectors
The solenoid valve system EVAP
Knock sensor
Potentiometer adjustment WITH idling (only for leaded petrol)
Sensor power steering (PSP) [2,0 liter DOHC]
:20. Throttle position (TP)
Replacing fuel level sensor (2.0 L DOHC)
Checking the fuel pump (2,0 l DOHC)
Checking channel clearing of the canister with the activated coal (2,0 l DOHC)
Check of the pressure created by the pump (2,0 l DOHC)
Replacement of the fuel filter (2,0 l DOHC)
Purification of the throttle device
Checking channel purification with charcoal canister (2.5L V6)
Replacing fuel level sensor (2.5L V6)
Checking fuel pump (2.5L V6)
Check of the pressure created by the pump (2.5L V6)
Replacement of the fuel filter (2.5L V6)
Adjusting the throttle position sensor (TP) (2,5 l V6)
The pedal and the accelerator cable
Fuel line
Fuel tubes and tubes of system EVAP
Fuel tank
PROCEDURE FOR TROUBLE
Troubleshooting
Ignition system
Coupling
Transmission
Power shafts, axles
Suspension
Steering
Brakes
Body
The air conditioning system
Electrical equipment
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Fuel line



Withdrawal

PERFORMANCE ORDER

1. Before releasing remove the fuel pressure in the fuel system, since, otherwise, the fuel under pressure will rapidly flow out of the fuel system.

To eliminate the spray of fuel close the connection point of the fuel system and a clean cloth, being careful, gently disconnect the piping.

2. Remove the fuel rail with the fuel injectors.

Setting

PERFORMANCE ORDER

1. Install the new nozzle O-rings.

2. Lubricate the O-rings of fuel injectors.

3. When installing the nozzles rotate around their axes in one and the other side.

4. Make sure the nozzle firmly inserted into the fuel line.

If the nozzle is installed correctly, the O-ring may be trapped. Remove the nozzle and re-install it.





« previos page
The pedal and the accelerator cable		 next page »
Fuel tubes and tubes of system EVAP

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.