REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Spectra
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
		Body
			Design Features
			Replacement bumpers
			Removal and installation of a mudguard and front wheel arch liner
			Removing and installing the rear wheel mudguard
			Removal and installation of a forward wing
			Removing and installing bonnet
			Door
			The trunk lid
			Removal and installation of facing the boot
			The fuel filler flap
			Seats
			Supplemental Restraint System
				Design Features
				Removing and installing driver's airbag
				Removing and installing front passenger airbag
				Replacing the front seat belt
				Replacement of a back seat belt
				Removal and installation of the electronic control unit an additional system of passive safety (SRS)
			Rear view mirrors
			Dashboard
			Removal and installation of the instrument panel
			Heater and air conditioning
			Interior fittings
			Replacing a windscreen
			Care body
		Car Care
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Applications
		Diagrams

printable version

Removal and installation of the electronic control unit an additional system of passive safety (SRS)

You will need: the key "10", flat-blade screwdriver.

1. Disconnect a wire from the plug ?�-?� the storage battery.

WARNINGS

After disconnecting the wires from the plug ?�-?� the storage battery, wait at least 15 minutes, after which you can proceed to the removal of the electronic control unit of the front airbags.

Connect the cable to the "-" terminal of the battery only after the installation of the electronic control unit an additional system of passive safety is completed.

2. Remove the lining of the tunnel floor (see. "Removal and installation of facing of a tunnel floor").


3. Pick up the lock pad lock harness ...	4. ... and open the lock by pulling the protruding edge.


5. Disconnect the harness connector from the electronic control unit an additional system of passive safety (SRS).	6. Remove the three nuts securing the electronic control unit ...

Removal and installation of the electronic control unit an additional system of passive safety (SRS)

7. ... and remove the control unit.

NOTE

When installing electronic control unit front airbags (SRS) is the arrow on the rating plate must be directed towards the front of the car.

8. Install the electronic control unit an additional system of passive safety and all previously removed parts in reverse order of removal.

« previos page
Replacement of a back seat belt

next page »
Rear view mirrors