 printable version
Removing and installing lights
For the safety of great importance is the correct alignment of the headlamp. Correct adjustment of the headlights is carried out by means of a special device, which is usually available only to the service station.
security measures
Be careful when replacing the xenon bulb in the headlights. There is a risk of injury due to high voltage! In any case, the headlight switch off and disconnect the battery. After replacing briefly switch on and off lamp, to remove the residual stress. For safety reasons, wear shoes with rubber soles.
Withdrawal
| 1. Open the hood.
2. Disconnect the negative (-) cable of the battery when the ignition is off. You must first remove the air filter box of the passenger compartment. 3. Remove the front bumper, refer to Section Removal and installation of the bumper.  | 4. Remove the screws (1). |
 | 5. Remove the bolt (2). |
6. Disconnect all connectors lights, as described in section Replacing incandescent exterior lights.
7. Carefully remove the screwdriver pneumatic hose block LDR automatic headlights.  | There is danger of damaging the connecting element. |
 | For models with xenon headlights pneumatic hose is fixed below the headlights. |
8. Carefully pull the headlight forward and pull out. |
|
Setting
| 1. Insert the spotlight in the recess of the wing.
2. Dock connector lights.
3. Secure the pneumatic hose.
4. Check the correct position of the rubber seal and, if necessary, correct.
5. Replace the three screws that secure the lamp.
6. Replace the bumper, refer to Section Removal and installation of the bumper.
7. Attach a weight cable (-) battery when the ignition is switched off. Replace the cabin air filter box. If necessary, enter the code for the radio and set the time on the clock.
8. Close the hood.
9. Check the adjustment of the headlights to the service station and, if necessary, adjust.
10. Models with xenon headlights: Set the zero position of the electronic unit for LDR lights at the station. |
|
|
