Removing and installing fog

1. Disconnect the negative (-) cable of the battery when the ignition is off. You must first remove the air filter box of the passenger compartment.

Before disconnecting the cable, find out the radio security code, if any, address to Section Replacement of the battery.

2. Remove the front locker, address to Section Removal and installation of a forward wing locker.
3. Disconnect the fog lamp connector.
4. Driver's side: Turn the lamp holder anticlockwise and remove it.
5. Driver's side: Remove the bolts and remove the front cover of the underbody, address to Section Removal and installation of the engine compartment lid from the bottom.
6. Driver's side: Remove the screws, remove the bottom of the water tank and take it to one side, refer to Section Removal and installation of the water tank and pump motor.

7. Remove the 2 screws (arrows in the figure) of the headlamp aiming.

8. Remove the headlight (1).

1. Insert the fog lamp so that the guide pins included in the bumper.
2. Secure the fog lamp with two screws.
3. Driver's side: Replace the windshield washer reservoir, refer to Section Removal and installation of the water tank and pump motor.
4. Driver's side: Attach the cover underbody.
5. Driver's side: Insert the cartridge with a lamp.
6. Dock connector lights.
7. Install the front locker, address to Section Removal and installation of a forward wing locker.
8. Connect the earth cable (-) battery when the ignition is switched off. Replace the cabin air filter box. If necessary, enter the code for the radio and set the time on the clock.
9. Check the adjustment range headlights and adjust if necessary to the service station.