 printable version
Removing and installing center console switch
The upper group of switches
Under the central ventilation deflector located hazard switch and switches for various purposes, such as the seat heating, the uniform lock, rear window wiper system and sustainability. Group breakers in case of failure of any element is replaced in the kit.
Withdrawal
| 1. Disconnect the negative (-) cable of the battery when the ignition is off. You must first remove the air filter box of the passenger compartment. 2. Remove the top of the center console, refer to the appropriate section.
3. Disconnect the connector group switches.  | 4. Remove the 6 screws (arrows in the illustration) and remove the group switches from the back side of the cover (1). (2) - the holder cover. |
|
|
Setting
| 1. Installation is performed in reverse order of removal.
2. Attach a weight cable (-) battery when the ignition is switched off. Replace the cabin air filter box. If necessary, enter the code for the radio and set the time on the clock. |
|
The console selector AT
Depending on the equipment installed in the console switches for heating the seat, as well as W / S-travel program.
Withdrawal
| 1. Disconnect the negative (-) cable of the battery when the ignition is off. You must first remove the air filter box of the passenger compartment. 2. Remove the selector switch, as described in Section Removal and installation of the central console.
3. Disconnect the connector (1) on the back of the casing frame from the strip circuit (refer to the accompanying illustration).
4. Lift the bracket (3) and remove the bar from the holder switches. |
|
Setting
| 1. Installation is performed in reverse order of removal.
2. Attach a weight cable (-) battery when the ignition is switched off. Replace the cabin air filter box. If necessary, enter the code for the radio and set the time on the clock. |
|
|
