REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
			Engine cooling system
			Ventilation systems, heating and air conditioning
				General information and safety measures
				Removal and installation of the control panel operation of the heating / ventilation / air conditioning
				Removal and installation of the cabin filter
				Removal and installation of the fan heater / air conditioner and control module
				Removing and installing heat exchanger heater
				Removal and installation of the circulating pump heating
				Removing and installing rear ventilation flaps
				Check the coolant level in the working path of the system K / V
				Removal and installation of gauges of system K / V
				Removal and installation of auxiliary fan assembly
				Removal and installation of the motor drive ventilation flap
				Removal and installation of the stepper motor drive mode switching valve air circulation
				Removal and installation of an electric motor drive the mixing flap
				Removal and installation of evaporator K / V and housing
				Removal and installation of compressor K / V
				Removing and installing condenser K / V
				Removal and installation of the expansion valve
				Removal and installation of receiver-dryer
		The power supply system and exhaust
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric
		Wiring

Removal and installation of the circulating pump heating

Details of the installation of the circulating pump heating

PERFORMANCE ORDER

Remove protection crankcase.
Drain the cooling system (see chap. Current care and maintenance).
Remove the engine cover / air cleaner (see chap. Power supply system and exhaust).
Remove the right air intake sleeve (1), - on models equipped with engine series 612, Disconnect the hose connector on the crankcase ventilation system.
Disconnect the connector (2) electrical circulating pump (M13).
Release fixing collars (3) and disconnect the hoses (4 and 5).
Remove the locker arch protection of the right front wheel.
Remove the mounting screws (6) and pull up, remove assemblage of the circulating pump (M13).
Installation is in the reverse order.
Finally, check the cooling system components for signs of leaks.