REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
			General information and safety measures
			The power supply system of petrol engines
				Checking and adjustment of the idle speed / ignition timing / CO
				Dropping the pressure in the fuel system, petrol engine
				The principle of operation of the control system and injection petrol engine
				Total system verification injection petrol engine
				Check injectors
				Removal and installation of components of an inlet air path
				Service elements throttle actuator
				Emptying the fuel tank
				Removal and installation of the fuel pump
				Removal and installation of the gauge of a stock of fuel
				Removal and installation of a fuel distributive highway and injectors
				Removing and installing fuel tank
				Removing and installing fuel injection control module (ECM ME-SFI)
			The power supply system of diesel engines
			Exhaust systems and reduce emissions
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric
		Wiring

Removing and installing fuel injection control module (ECM ME-SFI)

Details of installation of the fuel injection control module (1 of 2)


1, 2 - Bolt 3 - Support bracket module	N3 / 10 - (ECM ME-SFI)

Details of installation of the fuel injection control module (2 of 2)


4, 5, 6, 7 - connectors

PERFORMANCE ORDER

On models corresponding complete set (code ET2) activate the service mode of the emergency call TELE AID (see. Section Activate / deactivate the service mode of the emergency call AID TELE). Disconnect the negative wire from the battery.
Turn on the auxiliary battery and connect it to a standard battery, then disconnect the negative cable last. 7 - Auxiliary battery 8 - terminal positive wire module 9 - negative terminal wire module W10 - Ground Battery
Remove the front panel of carpeting in the passenger footswitch well. Remove the assembly module activation and the perception of the signal (SAM) with front-mounting fuse / relay box (see chap. Onboard electric equipment), - Do not disconnect the wiring. Remove the screws (1 and 2) and remove the support bracket (3) ECM. Disconnect the electrical connectors (4, 5, 6, 7 and 8), - do not forget to release the clips where they are provided. Remove the ECM ME-SFI (N3 / 10). Installation is in the reverse order - track correctness of laying and connecting the electrical wiring. In conclusion (with appropriate equipment) deactivate service mode of TELE AID (see. Section Activate / deactivate the service mode of the emergency call AID TELE) and clean the processor memory board self-diagnostic system (see chap. Systems of an electric motor).