printable version

Air nozzles

Management nozzles carried keys 1, 13, 14.

Extras can be individually opened or closed nozzle 3 and 4.

Nozzle closed: dial on the side .

The nozzle is open: dial on the side .

Depending on the position of the dial changes the air flow direction adjustment.

If the dial rotate under the grate deflector changes the direction of air flow in the horizontal plane.

Through the nozzles 2 saved nezapotevshey lower part of the windshield.

The rear nozzle placed in the area of the feet, are regulated in conjunction with the nozzle 5.

General information

Care should be taken so that the sensor is positioned between the air nozzles on the windshield in the middle of the dashboard and grille deflector (pos. 18) are not covered by anything.

To install "Climatronic" could function smoothly, the air intake in front of the windshield must be clean from ice, snow or leaves.

The heating capacity of the system is dependent on the coolant temperature of the engine cooling system - so the greatest heating occurs when at operating temperature engine.

If "AUTO" mode for a long time was not included, possible odor due to accumulation of various types of deposits on the evaporator.

To avoid unpleasant odors, should include climate control at the highest level of the fan - also during the cold season - at least once a month. In this short time to open one of the windows.

The used air leaves through outlets in the rear; These openings must not be partition off.

By Car sedan can not override anything the gap between the luggage rack and the rear window, which is used to remove the air.

At high temperature and high humidity outdoor air may condensate dripping from the evaporator and the formation of puddles under the car. This is normal and is not an indication of leakage of the system.

To prevent fogging of glasses at low speeds should include lower stage fan mode. Select this mode for "ECON" or "AUTO".

Cost-effective operation of the installation "Climatronic"

When operating the installation in the air cooling operation drive its compressor is driven by the engine, and therefore the character of use setting affects the fuel consumption. For the duration of the installation as possible to reduce the need to consider the following recommendations:

If the interior of the car is hot standing under the influence of solar radiation, it is recommended for a short time to open the windows or doors to ventilate the interior.

Do not leave included refrigeration unit while driving, when the sliding window or the sunroof open.

If the desired interior temperature can also be obtained without the inclusion of the refrigeration system, the mode of the "ECON".

Failures in the installation

If the ignition is switched on all the symbols flash on the display for about 15 seconds, the installation is faulty - contact a service company Volkswagen.