 printable version
Front fender
Fasteners front wing
1 - the front wing,
2 - screws 9 pcs.
3 - nuts, | 4 - Torx-T25 screws, 25 Nm
5 - nut 4 pcs.
6 - an arm |
Mud flaps front wing
1 - plastic nut mudguard,
2 - The location of the plastic nut on the mudguard,
3 - mudguard wing | |
Withdrawal
| PERFORMANCE ORDER | | 1. Remove the front bumper. | | 2. Remove the side repeaters turns. | | 3. Unscrew and remove the facing of a niche of a forward wheel. | | 4. Loosen the screws and remove from under the wing of the mudguard (see. Fig. Mudflaps front wing). If necessary, replace the plastic nuts in the mudguard. | 5. Remove the screws holding the front fender.
A warning  To avoid damage to paintwork, wrap adhesive tape place in the vicinity of the wing screws.
| 6. The wing is mounted on a protective layer of mastic, so the wing from the body protective soften the mastic with a hair dryer. On a hairdryer put on a flat nozzle and gradually warming up paste, remove the wing. In the absence of a hair dryer, remove the protective mastic with a sharp knife.
Consistently, from the reception, warm location of the wing on the mastic and, being careful to remove the fender of the car.
A warning To protect the underbody of the car used in the film based polivinilhlori yes (PVC), and it can be heated for a short time and not very much. When heated, the film changes its properties and bubbles. This release vapors harmful to health, and forms hydrochloric acid, which contributes to corrosion.
|
|
Setting
| PERFORMANCE ORDER | | 1. Before installing the wing in place, clean the mating surface and apply a zinc paste in the attachment points on the wing and the front wheel housing front (VW AKL-381 035 50). This paste is used as corrosion protection. | | 2. In other places, where the wing is mated with the body, stick sealing tape for the wings. | 3. Set the front wing on the car, align the bolt holes and tighten bolts, having tightened their moment of 5 Nm. When installing the wing, make sure that the gaps between the fenders and hood, as well as between the wing and the front door were uniform throughout.
The gaps when installing the wing:
Wing - hood - 3 mm.
Wing - headlight and the index of turns - 1 mm.
Wing - the front door - 4 mm. | | 4. Tightening bolts wing produce 5 Nm. | | 5. On the inner surface of the wing, apply a layer of anti-corrosion protection. | | 6. Install the side repeaters turns. | | 7. Replace and tighten the screws mudguard wing. | | 8. Install and tighten the screws trim wheel well. | | 9. Install the front bumper. |
|
|
