 printable version
Adjusting trunk lid / tailgate
Details of the rear door lock
| 1 - sleeve with left-hand thread,
2 - spacer,
3 - Tift notched,
4 - projections
5 - recess for the projection,
6 - bolt,
7 - the screw,
8 - a rubber buffer |
Adjusting the buffer back door
| 1 - sleeve with left-hand thread,
2 - rib pads,
9 - estigranny key 3 mm The gap a = 3 mm.
|
Installation projections valve
| 4 - projections
5 - a recess in the valve The gap b = 10 mm. |
Final adjustment of the buffer back door
The trunk lid / tailgate should be set so that closed the gap around the perimeter of the trunk lid / tailgate has been the same throughout. Also, when you close the boot lid / tailgate should be at par with the other parts of the body.
A warning  Adjusting the position of the tailgate / rear door must be carried out on the car standing on wheels.
| PERFORMANCE ORDER | | 1. Using a screwdriver blade, remove the pin with the notch and remove the buffer with a lid. | | 2. Remove the rubber buffer, then using trehmillimetrovy hex wrench, tighten the screw fastening until it stops and adjust the threaded sleeve so as to provide a gap of 3 mm as shown in Fig. Adjust the buffer back door. | | 3. Rib pads should come in contact with the threaded sleeve. | | 4. Replace the rubber buffer. | | 5. Remove the latch and set it so that the protrusions (4) includes a recess (5) latches, see. Fig. Installation projections valve. The distance between the housing and the base of the buffer rubber buffer should be 10 mm. | | 6. Gently close the rear door and open it again, after which the torque of 1 Nm then tighten the screw all the way, see. Fig. Final adjustment of the buffer back door). |
|
|
