 printable version
Hood
Fasteners hood
1 - hood,
2 - Front,
3 - a hose,
4 - a clip,
5 - washer nozzles,
6 - a casing joint,
7 - the screw 6 Nm | 8 - Joint
9 - a bolt, 25 Nm
10 - Rubber Stop hood. By varying the height of the stop by its rotation, changing height of the installation of the front hood,
11 - Rubber buffer
12 - directing hood |
Location and mounting of pneumatic support of a cowl
| A - spring bracket upper mounting support,
In - spring bracket lower mounting support, 2 - air support |
The site support X, for which the necessary support in the clamping vise
Withdrawal
| PERFORMANCE ORDER | | 1. Open the hood and enclose pure rags under cowl corners to protect the paintwork when removing the hood of the car. | | 2. Disconnect the hose from the washer nozzles and electrical connectors. Tie the hose and electrical connector thin long cord. Pull out the hood wiring and hose, and untie the cord from them, leaving it to the hood. In the future, it needs to tighten the cord in the hood wiring and hose. | | 3. Using a marker, mark the position of the hinges on the hood. | | 4. Ask the assistant to support the hood in the open position and remove the hood by a pneumatic support of a cowl. For this blade screwdriver to lift the spring clip and remove the top part of the support with a spherical joint on the hood. If you need to remove the pneumatic support of a cowl from the car, in the same way remove the lower part of the support, see. Fig. Location and mounting of pneumatic support of a cowl. | | 5. When removing air support bonnet not completely remove the spring clip from the ball joint, as otherwise the spring bracket is deformed and will have to replace the air support. | | 6. If installing a new air support, the support for the disposal of old it is necessary to remove the gas. To do this, fasten the support in the grip of the X portion shown in Fig. The site supports X, for which the necessary support to clamp in a vice. To avoid accidents, be sure to grip the support of the said portion. At a distance equal to 1/3 of the length, Saw body air support. When cutting support for the use of eye protection goggles. | | 7. Remove the screws holding the cover of the hinge of the bonnet and remove the cover. | | 8. Remove the bolts left and right hood hinges, and, being careful, remove the hood. | | 9. Check the condition of the hood hinges on the presence of backlash and wear and, if necessary, replace them. |
|
Setting
| PERFORMANCE ORDER | | 1. Using two assistants, set the hood and screw the bonnet hinge bolts by hand. Align hood hinges according to earlier made labels and tighten the hood screws. | | 2. Secure the pneumatic emphasis on the hood, what with force press until it locks focus on the spherical hinge of the hood. | | 3. Tie a cord to the electrical connector and the washer hose and retract them to the hood. | | 4. Put the hose on the windshield washer nozzles. |
|
|
