REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B5 (from 1996 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B5
		Instructions
		Maintenance
		Engines
		Cooling
		Fuel system
		Motor Control
		An exhaust system
		Transmission
		Chassis
		Steering
		Brakes
		Body
			general information
			Care body
			Care of an upholstery and rugs
			Repair of insignificant damages of a body
			Repair of strong damages of a body
			The front transverse panel
			Front bumper
			Removal of the lever locks the hood
			Adjust the side guides bumper bracket
			Rear bumper
			Front fender
			Facing of a niche of a forward wheel
			Air intake grille
			Hood
			Radiator grille
			A cable of opening the bonnet
			Hood lock
			Interior finish doors
			Differences at removal of an upholstery of the right front door
			The control unit door mechanism
			Door Seal
			Lateral furnish of a luggage space of models the Sedan
			Lateral furnish of a luggage space of models the Versatile
			The rear luggage compartment trim models Sedan
			Upholstery lid
			Upholstery tailgate
			Flooring luggage on Touring models
			The trunk lid
			Castle trunk
			Adjusting trunk lid / tailgate
			Lock the back door on models the Versatile
			The front door
			The cylinder lock of the front door
			The external handle of the door opening
			Door lock
			Manual lowering of glass of a door
			Glass doors
			Bracket door
			Interior rearview mirror
			The center console
			Front ashtray
			Rear ashtray
			Trim lever (automatic transmission)
			Decorative overlays under a radio receiver
			Lower trim the dashboard on the driver side
			Glovebox
			Inner escutcheon Door mirror
			Ceiling handle
			Sunshields
			Sill
			The windscreen and rear window
			The front seats
			Headrest
			Side airbags
			Rear seat
			The left rear seat backrest
			Carpet covering
			Elements of interior decoration
			Door mirror / mirror glass
			Exterior mirror housings
			Fencing / curb plank roof
			Side Panel Body
			Replacement of rubber tapes of brushes of screen wipers
			Windshield washer nozzles
			Wiper arms
		Heating, ventilation
		Electrical

printable version

Sill

Elements of interior finishes opening the tailgate

1 - a decorative overlay,
2 - a nut,
3 - screw with a fuse,
4 - a clip,
5 - lock,
6 - lug retainer
7 - sill

Fasteners pillar trim

1 - the screw,
2 - interior,
3 - Clip

Fasteners finishing bottom of the A-pillar

1 - plug,
2 - the screw,
3 - screw
4 - trim panel

Fasteners lining threshold

1 - the screw,
2 - plastic nut,
3 - sills,
4 - the door seal,
5 - Clip

Withdrawal

PERFORMANCE ORDER

1. Release clamps and tilt the rear seat backrest forward.

2. Loosen the nut (2) and unscrew the bolt (3) from the fuse. See fig. Elements of interior finishes opening the back door.

3. Remove the upper part of the decorative overlay of the time (4), then the bottom of the release latch projection (6) of the lining threshold (7) and remove trim (1) with a clamp (5).

4. Remove the screws (1) securing the casing (2) of the rear rack. See fig. Elements of fastening of an upholstery of a back rack.

5. Remove the lower A-pillar trim, which remove the cap covering the screws, then remove the screws and pull forward remove the finish from the overlay of a threshold and remove it from the vehicle. See fig. Elements of fastening of finishing bottom of the A-pillar.

6. Remove the screw (1) securing the rear of the pad threshold. See fig. Elements of fastening lining threshold.

7. Pull up to release the clamps securing the sill to the car body, and remove the sill of the car.

Setting

PERFORMANCE ORDER

1. Before installation, check the condition of the clips sills and plastic nuts and, if necessary, replace them.

2. Installation is made in sequence, return to removal.

3. Check the location of the door seal.

« previos page
Sunshields

next page »
The windscreen and rear window