 printable version
Windshield washer nozzles
Withdrawal
Direction clicking on the windscreen washer nozzles for removing it from the bonnet
Setting
| PERFORMANCE ORDER | | 1. Put on the nozzle fluid hose. | | 2. Connect the electrical connector to the heater nozzle and fix the wire on the hood. | | 3. Press the nozzle of a washer, lock it in the hood. | | 4. Check the direction of the jet of liquid sprayed on the windshield and, if necessary, adjust the washer nozzles. |
|
Adjustment
Proper spray fluid on the windshield
Location eccentric for adjusting the spray liquid height
The direction of rotation of jets in the rear window washer nozzles on models Universal
Location liquid feed points on the glass left headlamp
| A = 60 mm
B = 205 mm
C = 75 mm
D = 80 mm |
For vehicles manufactured before XII.96 position washer nozzles are not adjustable. If the liquid jet spray nozzle is at a different height of the windscreen washer nozzles need to be replaced on the adjustable washer nozzles, which are installed on models with I.97, the see. Fig. Proper spraying fluid onto the windshield. On vehicles manufactured from I.97 set adjustable nozzle washers that allow you to adjust the height of the liquid spray jet. For this purpose the base of the nozzle is set eccentric. By turning the eccentric counterclockwise jet liquid spray nozzle rises upwards, see. Fig. Location eccentric for adjusting the spray liquid height. Rear window washer nozzles on the Touring models should apply a spray of liquid in the center of the rear window. The direction of the jet can be adjusted by turning the jets needle or drill shank diameter of 0.8 mm, cm. Fig. The direction of rotation of jets in the rear window washer nozzles on the Touring models. If the direction of the liquid jet, the spray nozzle is not regulated or liquid stream is uneven, replace the washer nozzles. If necessary, blow compressed air nozzle washer. To do this, remove the nozzle and purge it from the hose connection.
A warning  Not blow nozzle in a direction opposite the fluid inlet.
Adjust headlight cleaning nozzle such that the liquid is sprayed onto the glass in a range points shown in Fig. Location liquid feed points on the left headlight glass.
|
